RETRACTABLE DOCK SHELTERS
For sealing from the bad weather conditions the back of the van against the building. Implemented with a channel to conduct the rain water from the roof into a channel and discharge the water laterally, inside the dock shelter.
The two frames are tied by a perimeter coat – side+top+side – that on the roof part has some holes, inside which the rain water penetrates and find a conveying channel of the water, to one side of the dock shelter, as to avoid the concentration of rain water on the roof, with buckets of water discharged on the head of the operators.
In case of wrong backing, the dock shelter retracts and returns to its original protruded position as soon as the vehicle advances
The cantered vehicle seals against the three front coats, that remain inwards as a flag
The retractable dock shelter is constituted by sendzimir galvanized steel parts, with front tied by a pantograph
On the two vertical strong side coats of double armoured PVC coated, 2,9 mm thick, 650 mm wide, are installed as “invard flags”. The top horizontal bar is implemented with a 1 meter high single armouring PVC coat, 2,5 mm thick, and stays down by gravity.
The whole perimeter (side+top+side) is covered by a single-piece PVC covered polyamide cloth, yellow for granting the inside brightness and avoiding the heat accumulation.
The top horizontal part has a channel in the internal part, where the rain water is conveyed passing through some holes in the roof. The rain water is conveyed on one internal side of the dock shelter, where it goes down to ground.
Amortizing system through articulated arms allow the dock shelter to retract in case of wrong baching, and return to the extended position when the vehicle forwards.
The standard retractable dock shelter is reinforced, in this version, by a spring-system for the front coats, that in case of severe strong wind shakings are cur along their steel supports. The reinforcements consist in portions of 3 mm thick double armoured PVC coated coat, one inside and one outside of the standard coats, 100 mm wide.
Triangles for the bottom sides apertures of the dock shelter.
Click here to identify the product code and the dimensions
DOWNLOAD DOCK SHELTERS CATALOGUE
REQUEST QUOTE FOR CAMPISA’S PRODUCTS
SEE OTHER PRODUCTS OF THE SECTION DOCK SHELTERS
Highly insulating, adapt to insulate the rear part of the van against the building, including the two…
The inflatable Campisa dock shelter is the ideal solution for insulating the rear part of the VAN against…